TC Helicon Perform VK

[David-san]

@sevarino

but also transmitting midi off notes

Hopefully, why shouldn’t be so?

@sevarino

So midi is getting to the interface but no further.

Why not?

If I remember well, our community member @bigalminal uses the TC Helicon Perform VK in his rig. Perhaps he could help you, if he is around…

I remembered well, we already addressed this topic here:

Midi not reaching the hamonizer

My harmoniser has been running happily via USB, and is receiving audio to determine the chords. There is a slight delay so I thought I’d swap the USB input to a midi cable to eliminate the latency. My controller is sending midi on Ch 14 and the midi monitor shows it is receiving Ch 14 data ok, but the hamonizer is not receiving any info. I’m using an iConnect Mio USB to midi cable straight out of the computer into the hamonizer. Should I be using a midi out block as well set to the Mio? I’ve tri…