Newbie here - tending to see things in an overcomplicated way. I’m looking for a simple way to control the mixer outputs in this rig: [Screenshot 2025-12-24 at 06.55.53] As you can see, the outputs from the mixer are going to Chord 1, Chord 2 and Chord 3. (each one of these is a Kilohearts Snap…

Variations will usually always be the best option, as you can change multiple parameters (via widgets) at the same time. One comment: if you’re never going to run multiple of your chord plugins at the same time, then they could potentially be wired in series. You would then bypass the two you’re no…

I don’t like variations. My solution would be to add 3 button widgets to my control panel for that rackspace. Set them up in a group where activating one turns the other 2 off. Have them control the mute on your mixer for each “Kilohearts Snapheap”. Then simply use MIDI learn for each widget so each…

Very helpful. Thank you. I’ll have a go at doing exactly that. I’m curious, though. What don’t you like about variations? I tried to make some but when I edited one, the other previous one changed, too, so they were exactly the same. I guess the whole point of them is that they are different in …

A song variation could use an entirely different rackspace. If I were to play something like foreplay / long time, the organ changes enough it might warrant a variation. However, even on that one, I can have 2 organ instances and switch between them using a widget. So, I don’t really need variations…

[image] Pippington: I tried to make some but when I edited one, the other previous one changed, too, so they were exactly the same. You are using widgets aren’t you? Variations will only store widget changes.

[image] _wo1f: If you have it across 2 variations, when you switch variations, the file play just stops. Assuming you have a widget attached to the “Play” function, you could configure your widget like the image below to prevent it from changing when you change variations. Note the “Ignore V…

[image] _wo1f: If you have it across 2 variations, when you switch variations, the file play just stops. Set the property “Ignore variations” for that widget

That makes sense. Very helpful. Thank you.

I didn’t know that. A great help, thank you.

[image] Vindes: Note the “Ignore Variations” switch. [image] dhj: Set the property “Ignore variations” for that widget Always learning something new. I’ll have to give that a try. Thanks.

[image] 6 Channel Template Shared rackspaces Hi all, After much experimenting, here is my “go-to” rackspace for AWAKEN - A Tribute to the Music of Yes. As many of you know, Yes music requires an extensive palette of sounds for each song. So I begin each tune …

Simplest way to control mixer outputs?

General discussion about Gig Performer

jeffn1 December 26, 2025, 2:01am 12

I use this on pretty much every rackspace. I includes widgets that can be used to mute mixer channels.