Hello everyone, Please excuse my English. It’s not very good. I’m a new Gig Performer user. Here’s my setup: FCB-1010, Tonex, Tonex stompbox I’d like my FCB-1010 EurekaProm! to control the modulation on my Tonex. FCB-1010 Pedal 1: chorus FCB-1010 Pedal 2: flanger For the CCs to control the T…

Hi @infospt , welcome to the family :wink: In the MIDI world CC32 is normally a CC for sending Bank changes.

[image] infospt: CC32 activates modulation CC32 and CC 0 are reserved for bank switching and so never goes to into GP or your plugin so you should change the CC32 on your FCB-1010 to something else Also, rather than sending MIDI messages directly to your plugin, use host automation instead. …

More info: [blog] Program Change Management Use host automation rather than MIDI to control plugin parameters - Gig Performer®

Thank you for your quick response. The Tonex requires CC 32 to enable modulation and CC 33 to select the chorus; for the flanger, it requires both CC 32 and CC 33. I’d like to have two buttons in Gig that turn on when I press the FCB-1010.

To be clear, you’re looking to have two widgets in GP that are triggered from your FCB-1010, and in turn triggering those widgets sends out CC32 and CC33 respectively to your Tonex pedal. Is that correct?

Is this chart for your Tonex pedal correct? CC 32 with a value of 0/127 turns off/on the Mod CC 33 with a value of 000 selects Chorus CC 33 with a value of 003 selects Flanger [000262]

If I don’t reply right away, it’s because I have to step away for a bit. When I get back, I’ll respond to your message. Thank you very much for your cooperation. Pierre

Ok, I have upped your permissions. You are not a “New user” any more. :slight_smile:

GP Home
Blog
Downloads
Store
Docs

Gig Performer Community

New user Gig Performer

General discussion about Gig Performer

npudar April 2, 2026, 3:14pm 4

More info:

[blog] Program Change Management
Use host automation rather than MIDI to control plugin parameters - Gig Performer®