New user Gig Performer

General discussion about Gig Performer
1

Hello everyone,

Please excuse my English. It’s not very good.

I’m a new Gig Performer user.
Here’s my setup:

FCB-1010, Tonex, Tonex stompbox

I’d like my FCB-1010 EurekaProm! to control the modulation on my Tonex.
FCB-1010 Pedal 1: chorus
FCB-1010 Pedal 2: flanger

For the CCs to control the Tonex modulation:

CC32 activates modulation
CC33 selects the modulation type: value = 00 chorus, value = 02 flanger

I’ve looked around the blog a bit, but I’m having trouble figuring it out.

Could you please point me in the right direction?

Thank you

2

Hi @infospt ,

welcome to the family :wink:

In the MIDI world CC32 is normally a CC for sending Bank changes.

3

CC32 and CC 0 are reserved for bank switching and so never goes to into GP or your plugin so you should change the CC32 on your FCB-1010 to something else

Also, rather than sending MIDI messages directly to your plugin, use host automation instead.

3 Likes
4

More info:

1 Like
5

Thank you for your quick response.
The Tonex requires CC 32 to enable modulation and CC 33 to select the chorus; for the flanger, it requires both CC 32 and CC 33.

I’d like to have two buttons in Gig that turn on when I press the FCB-1010.

6

To be clear, you’re looking to have two widgets in GP that are triggered from your FCB-1010, and in turn triggering those widgets sends out CC32 and CC33 respectively to your Tonex pedal. Is that correct?

7

Yes, that’s right

8

Is this chart for your Tonex pedal correct?
CC 32 with a value of 0/127 turns off/on the Mod
CC 33 with a value of 000 selects Chorus
CC 33 with a value of 003 selects Flanger

000262
000262492×230 4.28 KB

9

Yes, that’s right

10

If I don’t reply right away, it’s because I have to step away for a bit.
When I get back, I’ll respond to your message.

Thank you very much for your cooperation.

Pierre

11

Ok, I have upped your permissions. You are not a “New user” any more. :slight_smile: