Hi,
I’ve been using VB audio cable for a while and thought I’d post on using it to get system sounds into GP and for routing audio to QLC plus, both useful and free
First, you need to go to the VB-Audio page
download the vb and VBA+B cables ( small donation for VBA+B)
Install them
once installed you can see them by opening the control panel, also you can set number of streams bit len etc
Setup the VB channel to what you require (set to same as GP soundcard ( EG 48Khz)
Create an aggregate device with you GP soundcard, note since you aggregate device is adding the VB cable to the end of the existing card you can replace it in the Audio setting without losing connections
Name the VB in / out for ease of use in GP
Set your system sounds to VBA channel
Link your system sounds to your internal mixer / monitor and light mixer
Link your light mixer to your VB cable output ( note I use the outlaw as a Limiter adjust to balance the levels a bit
download and install QLC+ if you don’t have it
open QLC+ and goto audio setup tab, select VB cable
play some audio from GP or System and monitor in QLC+
app
Hope this may help some others wanting audio from GP to QLC Plus
Regards
Damian