Anyway to track down why the send and receive blocks of GP Relayer aren't connecting to each other?

Gig Performer on Mac OS X
1

For the past 2 hours ive been recording some stuff from GP 5.1.4 in to Logic 11.2 without any issues. In fact ive been very impressed that it hasn’t crashed as it used to.

Then all of a sudden, im not getting anteing coming in to Logic. Ive replaced GP Relayer in logic, but there is no activity coming in at all. I changed no settings before hand, so it’s not a setting issue, as all was working fine.

Ive rebooted, created a new Logic project, used a new GP relayer block in GP. Nothing. If I put a second Relayer block in GP, set to receive I am getting a signal, so I know the send side is working ok.

In Logic Sender Active and GP Application are lit up, but not Local host. Im guessing this I the issue?

Its working ok with Cubase, so I appreciate its a Logic thing.

Mac OS15.6.1

2

A sort of fix has been to remove Logic altogether and re ininstall it.

The first time I did it things were working ok, then I turned on Advanced mode and Local host stopped working. I again uninstalled it and reinstalled it, enabled Advanced mode and then reload the project. So far it’s still working.

1 Like