I’m running into a baffling issue with a stuck MIDI note and need some help troubleshooting.
During multiple sessions, a note became stuck and played continuously. I attempted the standard troubleshooting steps, but the note refused to stop:
Unplugged all physical MIDI devices/keyboards → Note kept playing.
Triggered MIDI Panic → Note kept playing.
Double-clicked Panic to restart the entire Audio Engine → The sound cut out momentarily, but the exact microsecond the audio engine initialised and booted back up, the stuck note immediately retriggered and kept playing.
The only way I could silences it was to completely restart Gig Performer.
Because it survives a total audio engine reset with no hardware connected, it feels like something inside the software layer (a plugin internal state, a latched widget, or a routing block) is immediately re-sending or caching the Note On event upon initialisation.
Has anyone experienced this before? What should I check in my wiring view or plugin settings to prevent this from locking up my system live?
So far this has happened on two rack spaces which both have significantly different wiring/plugins. Other than built-in/internal plugins there is no common plugin.
At the end of the day I need to know:
How to debug it when it happens?
How I might be able to stop it without rebooting GigPerformer
Switching rackspaces doesn’t work which I guess is to be expected. The whole thing about GigPerformer is that it keeps everything in memory right even when your not using it.
I was wondering that one way I might be able to break the cycle is by unplugging/replugging the inputs/outputs of the VST in the wiring screen while it is wigging out.
I had this issue, too, in the past but it was my fault. Between the MIDI Input block I had inserted a filter that blocked - among others - the “all sound off”/“all notes off” (CC120/123) used for MIDI panic.
And yes, “revert rackspace to last saved version” did the trick.
I think a bit more user interaction information is needed here.
Are you switching rack spaces, or variations?
Is the sustain pedal being used?
Is it always in the same rackspace?
Is it always the same plugin sound?
From my experience stuck notes are nearly always solvable by careful design. I have had plugins give stuck notes when a sustain with half pedaling is used, more than one sustain even though it is the same, on followed by on and off followed by off. Also bypassing MIDI in blocks for zones when you should be blocking note on. Blocking note on is a route to getting multiple sustain messages as these are still allowed through.